Racks US Robotics
Here you can compare the prices for racks US Robotics, get acquainted with photos and technical characteristics (for example Grounding set mounted, Cooling - rack rear doors, Coupling type, Dynamic load, Performance management, Power cords) and buy a liked model racks in one of the reliable online stores.
-
Product catalogs to browse
-
1U, 1360g, Black
Power Cable Management:
For models with redundant power available, it is strongly recommended that the second power adapter be used to assure uninterrupted monitoring. To eliminate power as a single point of failure connect the second power adapter to a different external power source circuit. To minimize power connector stress caused by suspending the cable and power adapter, it is highly recommended that strain loops be required for the cable and power adapter, it is highly recommended that strain loops be required for the power cable in this critical area.
power cable in this critical area.
Allow approximately ten inches of slack clearance between the power connectors and the power cable tie down. This will allow sufficient clearance to plug in the power connectors. Thread a cable tie down through the two 3/16” holes located directly behind the TAP device opening. Place the power cables in the cable tie down and cinch firmly but not so tight as to deform the cable sheath.
Trim the excess cable tie to minimize space and provide a clean cabling installation. Cable management considerations should deliver quality in installation consistent with industry standards to improve the level of cabling regulation compliance.
For models with redundant power available, it is strongly recommended that the second power adapter be used to assure uninterrupted monitoring. To eliminate power as a single point of failure connect the second power adapter to a different external power source circuit. To minimize power connector stress caused by suspending the cable and power adapter, it is highly recommended that strain loops be required for the cable and power adapter, it is highly recommended that strain loops be required for the power cable in this critical area.
power cable in this critical area.
Allow approximately ten inches of slack clearance between the power connectors and the power cable tie down. This will allow sufficient clearance to plug in the power connectors. Thread a cable tie down through the two 3/16” holes located directly behind the TAP device opening. Place the power cables in the cable tie down and cinch firmly but not so tight as to deform the cable sheath.
Trim the excess cable tie to minimize space and provide a clean cabling installation. Cable management considerations should deliver quality in installation consistent with industry standards to improve the level of cabling regulation compliance.
-
Payment Methods
We accept:
